Camshaft Position Actuator Solenoid Intake Inspection Form
Use this form to record vehicle details, intake-side solenoid inspection findings, symptoms, test results, and recommended follow-up actions.
Vehicle Identification
Customer / Owner Name
*
First Name
Last Name
Contact Phone or Email
*
Vehicle Make
*
Vehicle Model
*
Model Year
*
Trim / Engine Designation
Vehicle Identifier / VIN Equivalent
Current Mileage / Odometer Reading
*
Inspection Intake Details
Inspection Date
*
-
Month
-
Day
Year
Date
Inspector / Technician Name
*
First Name
Middle Name
Last Name
Inspection Location / Work Order Reference
Inspection Type / Source of Concern
*
Warning Light
Drivability Issue
Routine Diagnosis
Follow-Up
Other
Customer-Reported Concern / Description of Issue
*
Symptoms and Operating Conditions
Engine warning light status
*
Off
On
Flashing
Intermittent
Unknown
Observed symptoms
*
Hard start / no start
Rough idle
Loss of power
Poor fuel economy
Engine noise
Stalling
Limp mode
Intermittent issue
When does the issue occur?
*
Cold start
Warm engine
Idle
Acceleration
Cruising speed
Issue frequency
*
Always
Often
Sometimes
Rarely
Intermittent
Severity of symptom
*
Mild
1
2
3
4
5
6
7
8
9
Severe
10
1 is Mild, 10 is Severe
Additional symptom details
Were symptoms verified during inspection?
Yes
No
Partially
Not tested
Solenoid and Related Component Inspection
Visual condition of solenoid
*
Good
Damaged
Leaking
Contaminated
Disconnected
Not inspected
Connector and wiring condition
*
Good
Damaged
Loose
Contaminated
Disconnected
Not inspected
Harness damage or corrosion present
*
Yes
No
Oil contamination or sludge present
*
Yes
No
Mounting or fitment issue observed
*
Yes
No
Related intake timing or VVT component concerns
Cam phaser
Timing chain or belt wear
Oil control issue
VVT connector issue
Wiring continuity concern
Mechanical binding
No related concerns observed
Other
Test Results and Diagnostic Observations
Electrical Resistance / Continuity Result
*
Scan Tool / Code Status
*
Please Select
No codes present
Codes present
Pending scan
Intermittent codes
Other
Command Response Test Result
*
Responded as commanded
Did not respond
Inconsistent response
Not tested
Mechanical / Airflow Check Result
Normal
Restricted
Abnormal
Not performed
Overall Inspection Result
*
Pass
Fail
Needs further diagnosis
Technician Observations
Recommended Action and Follow-Up
Recommended Action
*
Clean connector
Repair wiring
Replace solenoid
Further diagnosis
Verify oil condition
No action needed
Urgency / Priority
*
Please Select
Low
Medium
High
Immediate
Parts or Additional Labor Needed
Technician Notes or Follow-Up Instructions
Submit Inspection
Should be Empty: